Hey guys, I was De-winterizing my boat last weekend. On my last seacock/Ball valve, Generator seacock (Buck Algonquin). Handle broke off. ARGH!!!
After looking at the thru-hull, It does not look good. Will need to change it out. Before getting hauled out, anyone know what size thru-hull it is? Hoping to buy the parts I need so I'm no not the hard for long, In and out.
Thanks guys for taking your time in reading and helping me out AGAIN...
Welcome to Carver Yachts Owners Forum
We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com
You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
2000 carver 506 - Generator Seacock/Ball Valve
-
KuyaJunGarage
Topic author
- Scurvy Dog
- Posts: 35
- Joined: November 23rd, 2024, 8:50 pm
- Vessel Info: 2000 Carver 506
- Location: Fairfax VA
- Has thanked: 7 times
- Been thanked: 1 time
2000 carver 506 - Generator Seacock/Ball Valve
You do not have the required permissions to view the files attached to this post.
-
bud37
- Admiral
- Posts: 5179
- Joined: April 23rd, 2015, 10:22 pm
- Has thanked: 602 times
- Been thanked: 1311 times
Re: 2000 carver 506 - Generator Seacock/Ball Valve
Off hand I don't know the actual size, sorry. I agree it sure is ugly looking though. Try a wire brush and clean the flats to see if the size is stamped there.
Just be aware to replace with quality bronze fittings.
So to be aware, once all that comes apart you may find there is more than just the valve that is worn out/corroded etc.
Just be aware to replace with quality bronze fittings.
So to be aware, once all that comes apart you may find there is more than just the valve that is worn out/corroded etc.
FWIW.....The above is just my opinion.
-
KuyaJunGarage
Topic author
- Scurvy Dog
- Posts: 35
- Joined: November 23rd, 2024, 8:50 pm
- Vessel Info: 2000 Carver 506
- Location: Fairfax VA
- Has thanked: 7 times
- Been thanked: 1 time
Re: 2000 carver 506 - Generator Seacock/Ball Valve
Bud, thanks for the quick reply. Yep, i plan on replacing the whole setup. to a true seacock (not a ball valve)
Always can count on BUD (my boat neighbor is name Bud as well!)
Always can count on BUD (my boat neighbor is name Bud as well!)
Return to “General Repairs & Maintenance”
Who is online
Users browsing this forum: No registered users and 67 guests
Sponsors