Global announcements
No global announcements
-
Latest Posts
-
Post 1993 Carver 300 Sedan Needs New Hot Water Heater
- Posted by: Dusty Bilges » August 8th, 2020, 1:46 pm
- Forum: AC/Heat, Plumbing & Sanitation
There's always something. Lost water pressure, and water was going into the bilge. I bypassed the hot water heater. That problem solved. Great pressure, no leak but . . . . .
Has anyone out there removed the hot water heater from a boat like mine where the hot water heater is under the galley counter??? I see a new heater is under $400 in West Marine, so I am hoping I don't have to use a Sawzall to get this done.
Views: 1249 • Comments: 1 • Write comments
Post Single 50A vs dual30A (60A) breaker
- Posted by: tonyiiiafl » August 8th, 2020, 10:57 am
- Forum: Electrical
Final chapter on my Kohler 6.5CZ genset. Looks like the previous owner removed the dual 30A=60A circuit breaker and replaced with a single 50A breaker. I found the proper breaker and was ready to install. Now remember I have NO ID plate on this baby to reference with confidence the spec version. So now I have both LINE leads from the gen head going to a single post on the breaker, and both load wires sistered up on the line side. The neutrals and grounds are set fastened to a single post on the ...
Views: 1146 • Comments: 1 • Write comments [ Read all ]
Post Replacement Shower Mixer - Alison 1050BX
- Posted by: vik1111 » August 7th, 2020, 10:04 pm
- Forum: AC/Heat, Plumbing & Sanitation
Guys,
I have a Carver 360 with a faulty shower mixer, understand new owner ‘Delta’ do not have a replacement model for Alson 1050 BX. Just wondering if any of you have replacement alternatives ? Don’t mind a used unit if its works.
Attached is the image with specs.
Any help will be appreciated.
Views: 1246 • Comments: 1 • Write comments
Post Likely new Carver owners - need advice quick
- Posted by: Awsmits » August 7th, 2020, 4:14 pm
- Forum: Introduce Yourself!
Hi, we are Allan and Diane, from New Haven, CT, and we just put an offer on a 1998 Carver 355 in the Annapolis area. Scary and exciting. So now begins the survey and sea trial phases.
We are hoping that other 355 owners can jump in and advise us on what to look closely at during the survey phase, and we would welcome any suggestions on surveyors in the Annapolis area that know used Carver motoryachts we..
Thanks! We look forward to talking and sharing with this community!
Allan and Diane
Views: 1918 • Comments: 6 • Write comments [ Read all ]
Post USB Outlet Options
- Posted by: Midnightsun » August 7th, 2020, 7:53 am
- Forum: Electrical
USB is changing and getting more powerful, charging laptops and quick charge on many phones not to mention USB-c which seems to be slowly taking over as the norm. I converted a few of my 12v outlets to standard USB several years back however the power output is not up there with todays standards so I went shopping for todays stuff.
If you are an Apple fan the you will want PD USB-c units which stands for Power Deliver. This charges your phone or laptop at 9v or 12v as opposed to 5 volts yet can d ...
Views: 1679 • Comments: 4 • Write comments [ Read all ]
Post New owner in Northern Ireland
- Posted by: PossiblyPaul » August 6th, 2020, 6:06 pm
- Forum: Introduce Yourself!
Hello, all, I'm a new owner, along with my son, of a fairly old but sturdy Carver 2827 (1988) which came with two Penta TAMD31s. The previous owner had her for 15 years, here in Northern Ireland, and has looked after her well.
Some issues which are getting attention; smoky starboard engine, and a very stiff throttle on it, and the trim tabs aren't behaving. Those, and some upgrading of the electronics, will be attended to in coming weeks - a great pity it's the middle of the season here; so muc ...
Views: 3739 • Comments: 14 • Write comments [ Read all ]
Post Finally got my Carver
- Posted by: Captain Cigar » August 6th, 2020, 4:55 pm
- Forum: Introduce Yourself!
Hi all
I have been a member for a few months but did not own a Carver until this past Tuesday. We closed on a 1995 430 CPMY. Beautiful, clean boat. Survey turned up a couple of things but nothing major. All in all in very good shape. It needs to be trucked to Lake Lanier in Georgia which will be in 2 or 3 weeks. Cannot wait as I have been boatless for about 5 weeks.
Views: 2338 • Comments: 9 • Write comments
Post 1995 355 rudder packing leaking
- Posted by: CarverDogg » August 5th, 2020, 4:21 pm
- Forum: General Repairs & Maintenance
Hello I noticed my ridder packing is leaking on both port and starboard side. Anyone know the cost of this repair or had this repair done?
Views: 1070 • Comments: 1 • Write comments
Post Shore power, white 30 amp cord, marinco 30 amp y adaptor
- Posted by: bud37 » August 5th, 2020, 4:11 pm
- Forum: Boat Parts For Sale
For interested people on Georgian Bay or very near there.
I have one marinco y adaptor ( 30 amp ),like new, rarely used......and one white 30 amp 50' shore power cord, like new, rarely used.Both of these have been at the house. I will deliver these things if you are close with in reason, just buy both.
Couple Weaver dinghy standoffs and two transom brackets as well, don't know who made them...shiny SS.
Shoot me a PM ....
Views: 1275 • Comments: 0 • Write comments
Post Bilge Pumps Refit - High Water Alarms
- Posted by: vineyardgray » August 5th, 2020, 3:47 pm
- Forum: The Project Center
My 3867 Santego does not have high water alarms, something we found out by surprise on her inaugural voyage from Belleville to Port Credit. Thankfully the leaking heat exchanger did not overwhem the bilge pump in the engine compartment and we made it home nonetheless.
However, this experience did not particularly sit well with me; had I not opened the engine baycover on a whim, the engines could have well been underwater without warning.
Then this season I found the engine bay float switch bl ...
Views: 8865 • Comments: 30 • Write comments [ Read all ]
-
- Last post
-
-
Last post
Re: Welcome to CarverYachtOwn…
by waybomb View the latest post
-
-
General Boating Discussion
This forum is for general discussion of all things Boating. If it's boating related and doesn't fit in another forum, post it here!Topics: 806, Posts: 6632 -
Last post
Re: Window Diagram/Blueprint
by km1125 View the latest post
-
-
-
Carver Yachts Forum - Model DiscussionThe is the forum to discuss general information regarding all Carver Yachts.Topics: 875, Posts: 5991
-
Last post
Re: Ceiling Vents in the Salo…
by bud37 View the latest post
-
-
-
Boating & Cruising LifesyleChat with fellow Carver owners about cruising destinations and more. Plan rendezvous, raft ups & get together's here.Topics: 164, Posts: 1881
-
Last post
Re: Mona passage to PR
by RambleOn506 View the latest post
-
-
- Last post
-
-
The Project CenterTopics: 450, Posts: 4091
-
Last post
Hydraulic Pump Question - Gar…
by NHCarver346 View the latest post
-
-
-
General Repairs & MaintenanceAnything related to the operation of your boat. Steering, Bilge Pumps, thru-hulls, bottom paint, etc.Topics: 1890, Posts: 13384
-
Last post
Re: 638 santego crank shaft c…
by bud37 View the latest post
-
-
-
Gas Engines/TransmissionsGAS engine, transmission and generator repair and maintenance discussion forum.Topics: 648, Posts: 6502
-
Last post
Re: Raw water pump fittings
by Kruggy88 View the latest post
-
-
-
Diesel Engines/TransmissionsDIESEL engine, transmission and generator repair and maintenance discussion forum.Topics: 182, Posts: 1176
-
Last post
Re: 2000 Carver 506 - 6CTA Cu…
by Sump99 View the latest post
-
-
-
Electronics & NavigationDiscussion of radars, GPS, autopilots, stereos and TV's. Also iPad and other mobile navigation devices.Topics: 244, Posts: 1700
-
Last post
Re: Transducer cable run
by bud37 View the latest post
-
-
-
AC/Heat, Plumbing & SanitationDiscussion of AC's, plumbing and sanitation related issues.Topics: 532, Posts: 4402
-
Last post
Re: 355 airconditioning ducti…
by buster53 View the latest post
-
-
-
ElectricalDiscussion of batteries, chargers, wiring, generators, distribution panels, battery switches, etc.Topics: 581, Posts: 5779
-
Last post
Re: Westerbeke gas generator
by MyPleasure View the latest post
-
-
- Last post
-
-
Carver Boats For SaleList your Carver Yacht for sale here. All listings are free for active form members! ALL ADS ARE FREE - USERS MUST HAVE AT LEAST 10 POSTS TO PLACE AN ADTopics: 122, Posts: 376
-
Last post
1985 Carver 3607 available
by Grafunkus View the latest post
-
-
-
Boat Parts For SaleUsed boat parts, used Carver boat parts, trailers, dinghies, outboards, props...everything but the boats they were attached to. ALL ADS ARE FREE - USERS MUST HAVE AT LEAST 10 POSTS TO PLACE AN ADTopics: 259, Posts: 1027
-
Last post
Bert Rod holders
by dianesmallings View the latest post
-
Who is online?
In total there are 554 users online :: 5 registered, 0 hidden and 549 guests
Newest members
- Username Joined
Kwat21 03 May
Michael0972 01 May
GaryMac 30 Apr
Odyssey1! 30 Apr
rgodales 30 Apr
kuli_vt 29 Apr
BoogsNBohs 28 Apr
JThompson 27 Apr
Statistics
- Totals
Total posts 68177
Total topics 8193
Total Announcements: 0
Total Stickies: 4
Total Attachments: 6673
Topics per day: 2
Posts per day: 14
Users per day: 2
Topics per user: 1
Posts per user: 6
Posts per topic: 8
Total members 11568
Our newest member Kwat21
-
Birthdays
-
- No birthdays today
In the next 30 days
No members have a birthday within this period of time.
Sponsors