How/where to run a transducer cable from the stern area to the flybridge on a 325 carver 1998 aft?

Hey everyone! I just purchased this lovely 98 355 and on a 450 mile river run home I started having a issues with my port engine, after running for 1 1/2 -2 hours she starts losing rpms. I start out at 3200 rpms on both engines but the port engine will start losing rpms down to 2600 with the throttle wide open, after she sits overnight its fine for another 1-2 hrs. Any help would be awesome. Thanks

Hi everyone,

Hope all are staying safe and healthy.We are transporting our boat from MN to CA. and realized our bimini (top portion only) is in need of replacement. Carver no longer has the pattern. We have the material and our current top. I realize a custom fit is best but have spoken to a marine canvas maker in CA. who can pattern it with our top. He says having the pattern is key. Anyone have this pattern or original dimensions? or a recommendation for a custom shop in Marina Del Rey?

...

I bought a Promariner ProNauticP Series 1240P 3 bank charger to replace what I guess is the original old faded blue charging unit. I’m not sure if the original is a single bank that connects to a bus bar or something? Haven’t looked real close yet. I just wanted to drop in here and see if y’all can offer any advice and or gotchas I should be considering before going down to the boat. For example, I have a huge 8D battery on port and one on starboard and a regular starting battery for the genset, ...

My brother in law walked through mine. Don’t ask!

Any help would be appreciated. Carver 33 SS 2006 vintage.

Have 1990 Model Carver.

Isolated leak in my pressurized water system to T fitting... leaking at the joint where the tube is inserted in the fitting.

Have Grey plastic tubing and rubber hose tubing 1/2 inch going into fitting.

Need suggestions on how to repair since the fitting and tubing is out of date.

Free is perfect but I don’t mind paying either. I’m chasing a short somewhere and it would be nice to know where wired run. I also think I have a leak somewhere I can’t see because there’s always water in the galley hatch compartment. I’d like to find a schematic that shows how things were run so I can track the all pipes down

I've searched and searched and searched... Having no luck. I need to change out the impellers on both engines, Crusaders serial 66544/45. Also I need to repack one shaft. Can't find any information on matching replacement parts and nothing on the size of the packing material. Is there a place to find this information? The boat is in the water and I'm a bit terrified of not having the correct packing material on hand once the old has been removed. Any help is greatly appreciated.

Any observations would be greatly appreciated. My 2000 Carver 396 has an old SIMRAD system. Radar works fine. Previous owner installed new depth finder that works fine. Chart plotter does not work. I tried replacing the GPS antenna thinking that was the problem but it was not.



I am interested in a new chart plotter with auto guidance or dock-to-dock capability. Basically a chart plotter that does just that and doesn't break the bank. Perhaps a smaller screen device that can be mirrored to ...

Has anyone replaced their Apelco fish finder 360 while still maintaining the original transducer and cable connection? The display is shot but have verified the original transducer and cables are working fine . Finding a monitor this old is impossible , so trying to find a Suitable replacement without re-wiring.