I want to Install a Purasan in My 2004 Mariner 360. ANy ideasa or experience with an install in this model?

I believe this was mentioned before, but I usually winterize my A/C by opening the strainer and pouring pink stuff in while i. Is running to push it through the system. kind of a PITA because the strainer goes dry and have to wait for the pump to pick up again. I thought I saw a post here that someone put a 3 way ball valve on and opened it to allow the pink to be pumped by a separate pump through the system?

'89 Carver 3607 Aft Cabin
Mercruiser 7.4L Blue Water Inboard Thunderbolt IV Ignition (gas)
What is the manufacturer's recommended oil filter and fuel/water separator filter?

Kohler Generator
Model 785R63 (I think)
7.5kW Single Phase 60 Hz
Looking for same manufacturer's recommendations as above.

Thanks!!

With spring approaching I want to tackle an issue from last season.
When we purchased our Santego last spring one of the big selling factors was the nice big extended add on swim platform.
The platform sits very close to the surface of the water and thought that was a great feature. Nice and roomy and easy to re-board the boat from a swim.

However we noticed it dragged in the water when underway especially when attempting to get the boat on plane.
Then it started to become loose. As in almost fallin ...

Greetings all,

I have been a long time Carver owner (1987 Carver Montego 3257) and just discovered this forum.
We love our boat (Just Another Grand) except for the lack of a radar arch... and a few deck blisters. Ahhh the joys of owning an older boat!

We just purchased a 2000 Carver 53 Voyager. When we are connected to Marina water every faucet works great, including our shower in the master. When we use the water pump, our master shower has zero pressure, both from the faucet and if we switch to the wand. Every other faucet works perfectly. Any suggestions would be greatly appreciated.

Hi everyone!
I am the original owner of a 2015 Carver C40. Prior to that, I had a C34 ....

I have worked my way thru quite a few 'post warranty' issues over the years (and still running into them routinely .

Looking forward to the forums!

Dennis

My water heater is rusted out and leaking on my 2000 Carver 530, I am going to replace it. Anyone have recommendations or suggestions on how to remove the old one and get the new one in? I'm thinking I may have to remove the outer housing of the tank. I may also be able to make it fit by removing a few things, but it's still going to be one heck of a tight squeeze. Any suggestions or tips would be greatly appreciated!

Good morning, everyone,

Hope y'all are having a great start to the week.

I'm currently in the market for a new 16,000 BTU self-contained A/C unit. Wondering what brands would you guys say are the best performing at this time?

I've always had dometic up until now, but have been hearing good things about webasto lately, and previous experiences with Dometic's customer support left me a little less than excited about getting another one of their units.

If you are familiar with webasto, what unit would ...

Hey everyone.

First time boat buyer here - looking for something to live on a few days a week.

I like the Carver Mariner 32 with a dedicated shower stall - open to other options too. Ideally would like little to no engine work, but happy to do any TLC on the inside. Looking to move pretty fast Something under $25k I can pay lump sum!