2000 325 Aft and gauge registers empty under all circumstances. I believe the tank is located in the aft, however I am curious to know if anyone else has experienced this and is it more often the gauge or the float/sender from the tank?

Hello a i just purchased a 98 carver mariner 350. First time I’ve owned a carver and am happy so far. If anyone knows where i can get the oem Bimini i would really appreciate the help. Previous owner somehow lost just the top to the bridge enclosure. Glad to find a site with lots of info.

1987 3607, did it come with 1 or 2 blowers? My boat has 2 and if you turn on from the bridge and then also turn on lower helm switch it sounds like they either sped up or the 2nd one comes on. Are they wired separate or does turning on lower helm switch also push more electrical current to them and increase their speed? Some things will drive you crazy about a boat.

I have had a an Achilles inflatable and figured it was time for an upgrade. So I will call my self a New Boat Owner. My son and I recently bought a 1988 Carver Montego 2757.
The boat runs well and we have had a couple good runs but keep finding various nuisances as is to be expected with a boat. I figured I would check into this forum as I am sure others have experienced the same minor inconveniences as we have.

The Tri-Data speed and mileage log stopped working this weekend on our 350 Mariner. Depth gauge works fine but speed and distance log shows zero. I'm thinking there must be something blocking the paddle wheel. Does anyone know the location of this wheel? I was hoping I could try to brush it when anchored out next but do not know its location.
Thanks for any suggestions other then lifting out of the water.

All, I've been having an issue with my CO2 alarm going off since installing my generator that I want to see if anyone has any pointers on.



Since my boat didn't have a generator originally I wonder if my boat might be different in some way, what I'm finding is that heat, and I'm sure fumes, are entering my cabin around the rear salon panels because the bottom of this area of the structure is "open". Can anyone with a Mariner comment on the factory insulation that might have been used in this area ...

Hello, I am looking for a replacement Black and Decker SpaceSaver II coffeemaker that came installed from the factory. They were discontinued, but I am hoping someone out there has a working one squirreled away somewhere. We currently have an empty void in our galley cabinet because the previous owners of our 466 were tea drinkers.

Does anyone know how where the grey water tank is in a carver 300? I am not sure it has one, the galley sink discharges over the port side but the head and aft cabin show no discharge. Seems like it might be behind the head but I can't access it. Thanks, Pat

Can someone please tell me the compass location in our 2005 56 Voyager. I understand that it should be aft and low, perhaps on the aft bulkhead. Generator located there, so not obvious where find it. On edit, I see this should have been posted on Electronics, oh well.
TIA, Keith

Hello i have 2 crusaders 350 in my Carver 28. After winter one of the engine dies as soon as i rev. Me and my father got it running after putting it in the water by pinching the fuel line (Desperate matters becaus both prop shaft packings was leaking like hell untill i put it in gear). After that it run nice and was responding on throttle. but when i started it again after moving it to the docking place it one engine dies as soon as i giv it throttle, runs on idle but not on throttle. What can c ...