This is a 3867 Santego with 704 mercruiser blue water engines with 1000 hrs. and a 6.5 Kohler generator with less than 300 hrs. It has a raymarine C120w MFD 4kw radar and depth finder. The boat is fresh water and has many upgrades. It also has a 2015 survey. Call 708-269-8327 for details.

I just purchased a 2005 carver 46. Is there a recommended make and model replacement?

I have never stored a boat on the hard for the summer season when it is hot up here in Ontario. Right now it has a vented canvas type fitted tarp on it. Wondering what the best course of action is, leave the tarp up or take it down for the summer and put back up in the fall. The last few days has been quite hot under the tarp....salon ok but bridge hot.



The question for those of you that have stored on the hard in more southern areas where it gets hot longer thru the year....how/best way, to d ...

Good Day All,

1997 Voyager 320.

Our A/C had been consistently tripping out. Had a tech in to troubleshoot, diagnosed a seized compressor.
He indicated this is a hermetically sealed unit and the only option is to replace.
Has anyone on here had the same issue? What was the correction, repair/replace?
Any insight would be greatly appreciated.
Thks

My starboard drive shaft sheared off. Insurance says it was a mechanical failure so they aren't covering it even though I clearly hit something. I am finally moving forward with the repair but am trying to find a prop that isn't $1700. Any idea where I could find a used or reconditioned prop?
22 X 22RH 1-3/8"

Thanks,
Alan
1993 Carver 350 Aft Cabin

Hey folks. Here is one for the experts.

I have a 2005 vintage Kohler 7.3 generator. Its a well maintained unit, new impellers every year, new carb 2 seasons ago. Heat exchanger boiled out with new carb installation. It was running great until.... it stopped running great.

The issue that I have is when at the dock or idling about she runs great. With a full load, its smooth sailing. Sometimes 'searches' a bit if the compressor on one of the a/c units turns off, but that seems par for the cour ...

I'm considering putting SeaDek flooring on the swim platform and flybridge steps on a 2000 Carver 350 Mariner. SeaDek informed me they have a template for a 2002 350 Mariner. I'm wondering if there was any changes between these two model years.

Hey everyone my boat was moved recently for the marina to make some repairs to the pylons. When they moved it back they rode my bow thruster way too much for some reason and it stopped working! (I know this because unbeknownst to them I happened to be listening in on my security system).



So I just got back to my boat and was testing it and I can hear the motor running when I use it but the thruster isn’t thrusting?



Any ideas on where to start troubling shooting or fixing it?



Thanks for any advise!

While cleaning my engine room bilge, I found this guy at the bottom. Any idea what it is used for?

Ok, this is probably going to be one of my most embarrassing posts. So last fall I purchased an 03 396 with Cummins power. I think I may be low on Power steering fluid (or should I say Hyd fluid) as my steering is a bit difficult as I go from one extreme to the other. What would any semi-handy guy do?? go fill the fluid, of course...

guess what... I can't find it! can anyone tell me where it is??

I'm so embarrassed...