Any one know where I can buy a replacement exhaust flapper for my '89 Carver 3607?

My boat ,a 1980 3326 Voyager. Is in need of the steering wheel and hydraulic hookup for the lower station. Everything else is there but no steering wheel.I

Anyone know of boat salvage yards in Western Lake Erie area? Maybe I can locate a 1980's Carver.

I am having an estimate done from a person to do the buff/wax job on my Mariner. Her quote will be done Friday. What do you all think would be a reasonable expense? She does a 2 or 3 step process, compounding/wax, and I have seen some boats she did. They look really nice, but they are a different brand. I usually have a pro job done every other year, and do off years myself with a one step cleaner/wax. Any input? What do you pay on the 32 -33 foot range? Thanks for the input!

er

This has always been a pita to say the least. In my case the hose is permanently connected to city water which gets detached from the boat and left at the dock when out cruising. I always shut the valve off when leaving the boat for the week other wise it is always on when we are at the boat or even away for a few hours running errands. that being said these cheap "RV/Marine" hoses tend to swell to the point of looking like they will explode. So I searched to find the best alternative.

I should m ...

28 ft voyager, twin 230 gas, 4 - house gel 6 V. batteries w/ inverter

I'm getting intermediate reading of 10.5 V on "bridge" circiut. It Runs VHF radio, 1040SX gps & radar. I have 12.2 @ control panel switch w/ engines off and 99% SOC on house system. Where could my two volts go?

All of a sudden the gas fumes on my boat have become extremely noticable and unbearable and a serious fire hazard.

It currently has maybe 10 gallons in each tank and I believe the problem is coming from my fuel filler hoses and vent hoses based upon what I have read in thusforum and others.

I've also been told that changing them out is a fairly easy task that can be done myself.

Does anyone know if there are any step by step DIY directions or videos of photographs showing this being done or can ...

Need member from Portland Oregon and have a 94 37 Carver Aft Cabin with twin gas engines with a direct pipeline to my wallet is

A beautiful day so we took the fishing boat out for the yearly cruise around ??? Some of you from the area may know.......

We bought Agradecida (grateful in Spanish), a 2003 356, last September. She was near perfect when we surveyed her. We spent the winter buffing and updating her electronics package in anticipation of our up coming summer. When it finally arrived we put her in the water in Racine Wisconsin in mid April. Mid June we left for our trip to Door County Wisconsin where we spent a month and a half living on her. About half way through our trip the admiral said "why do we have a boat, an apartment in Raci ...

The end of my season is closing in fast. Saturday I dumped in some Stabil and motored over to the fuel dock to top off my tanks. 71 gallons and $330 dollars later my tanks were full. I then motored out on to the Detroit River and ran a couple miles up river and back to burn off some fuel. I figured that I burned off about 3 gallons from each tank.



I will probably take another short ride the day I motor over to the lift to be pulled from the water. All in all its been a pretty good season. I did ...