While on a one week trip this past week I decided to check all the bilge blowers as I could only hear the generator blower from the bridge. Upon inspection I found out that both engine room blowers were not working. I first ruled out the switch and breaker and found power to the blowers so assumed both were just burnt out. I arranged to have two blowers delivered to the marina we were at and then installed the starboard one as access was somewhat easy. My problem now is getting to the port side ...

Hello all. Is it necessary to remove the window frame from outside to accommodate replacing the felt channel? Thanks. Doug

Gotta lean on the Carver community for some help with my windlass. 2004 360 SS, Maxwell 880 windlass. Everything works except the down switch on the helm. Both foot switches work and the up control on the helm switch works too. After troubleshooting, I replaced the switch and still have the same result.

Thank you for any guidance you might have.

Hi,
I have a leaking water faucet in the aft cabin tub of my 506 MY. I cannot find a way to remove the handle for the cold water. Has anyone done this before ? In my house, I have removed the faucet handles by removing a top cover piece and then unscrewing the handle. I cannot find a top cover piece to remove here,,, See picture below for the style.

Any thoughts ?

Thanks,
Jim

Good morning,

Is it difficult to get to and repair bow thruster? looking to purchase 2003 Carver 366 aft cabin. has anyone had issues with these?


Steve.

Looking for an original swim ladder for our 1988 3207. I know there's a couple different models that fit. I would just like to have the original equipment as I like the look of it folded up with the original teak steps.

Hi there,

Finally joined up because I've seen a lot of decent info on this forum. My wife and I have a 1988 3207 out in Las Vegas, NV. I'm sure there's a couple more people on here from the valley. Say hello if you are maybe we'll see you out on Lake Mead.

-Ryan

Hey all

Anyone know if the deck plates on the back cockpit area of a 350 Mariner are solid fiberglass or are they wood core?

I am putting this out there in the event any Carver owners have similar issues with their Volvo Penta electronic throttles.



I have a 2006 Carver 44 CMY that is fitted with Volvo Penta D6 Diesel's that are controlled by the Volvo Penta electronic throttles.



I was on plane running across Georgian Bay at 3100-3200 rpms. I noticed a siginificant RPM drop on my starboard engine. The starboard throttle is the slave and sync's with the port. When I moved the throttle forward slightly the RPM's would ...

DOes anyone know the rudder angle of a 1994 390CPMY? My new autopilot is asking for it.