Ok, not sure what to call the pieces that are fabric trimmed around the cabin. They are around the windows, over the galley, etc...



Anyway, has anyone ever removed them to be recovered? Some of you may have seen that I have just completed the carpet project and now want to update and match the fabric soft goods around the cabin. Some pieces have been simply glued on, and will get those off just fine... but area’s like above the galley I’m just not sure? There is a wood trim blocking behind ...

Hi all, here we are back to another season. First trip out today, all is well for first time in years. smooth as can be. engines started up on first try. I know you are saying probably, why should they not but if you look at my older post, its been hell. Anyway, getting back to a new issue, hope it is not an issue though. I have maxwell P19220 Up/Down Remote Panel light indicator I noticed was on as I was locking up the boat for the week. I never notice the light before being on. It ...

Replacing fresh water pump on a 1987 3607, what is factory pump size and would a 5 or 6 GPM pump give good water pressure? thanks for your help.

As my wife starts the replacement of the eisenglas, I'm going to start on transforming this original pink (the last of it!) table into a teak veneer table.

Hello, I have a 1992 330 aft cabin. I just purchased the boat and now I’m trying to work out the bugs, after filling the fuel tanks gages only read half tank on both tanks, I was wanting to check the sending units. Has anyone had the sending units out and what is the easiest way to get to them.

Thanks Mike

97 355 aft , starboard side discharge AC thrull is cracked a little on outside. (White plastic) , want to replace before it becomes an issue. How or where do you access them from inside? I opened up the all the cabinets in the the aft head and under sink thinking that's where they would be, nope! Could not even see them when I took out the night stand and looked back to starboard wall of the hull. Any info appreciated.

Does anyone have the part number for a replacement impeller kit for the gen 5 merc 7.4 belt driven (fuel pump on top) raw water pump? I have a spare new pump, but it has been in the box for a year now, so I thought I should replace the impeller before installing. I replace them as per Merc recommendations of every 3 years. I swapped out the starboard one last year, will do the port one this year, and have a year off next year. A lot easier having one to swap out than replacing while on the engin ...

Hey Folks I installed a clamshell on the forward bilge thru hull. I will let you know if it prevents the back flow into the bilge.

Looking for some advice.... Just purchased a 1989 Carver 4207 with 3208 Cats. It has a bad fuel tank on the port side and my plan is to replace the tanks on both sides. Anyone on here have any experience/advice on the best way to proceed and/or things to avoid?

Thanks,

1st time owner and bought an older boat.Yes I get the irony in that.Wanted to reseal the deck rail plate screws but some of them are stripped as well as some of the cleat screws. Thoughts,ideas.. help?