I buy from this site for my carwash and happened to notice some really good priced on clearance thu hull fittings. Bronze and chrome plated bonze. Here is a link to one of them.

https://www.freshwatersystems.com/colle ... -nut-1-1-2

looking for possible causes and fixes. Port engine showing low oil pressure. Oil changed 8 months ago.
Levels good. Oil looks good. Engine temperature normal. has anyone else encountered this issue? Would love ideas on what to look for?
Barb

Folks...

Just bought this boat.. noticed it slopes about 1.5-degrees forward. Is that normal for this model?

Also, Can anybody tell me the location of the inline waste tank vent filters for a 2001 model 444? My friend has a 2003 model, but my filters aren't in the same location as his -- can't find them anywhere and my wife is throwing fits if I don't get them replaced.

Thanks.

Folks...

Can anybody tell me the location of the inline vent filters for a 2001 model 444? My friend has a 2003 model, but my filters aren't in the same location as his -- can't find them anywhere!

Thanks.

Last yr I purchased a 2002 Mariner 350 that has 4 batteries in it. When the boat arrived and looking in the engine room a worker at the dry dock noticed the batteries are all linked together and mentioned he had never seen this. I have been unable to separate the batteries using the aft cabin battery switch ( 1, both, 2 ) therefore my batteries are going dead while out for 2-3 days. They are wired in parallel series and I would like to hook them up correctly, individually.



If anyone can send me ...

I just got a 1993 Carver 300 Sedan which I had transported about 200 miles, and the wind blew off part of the smoked glass windscreen that surrounds the flying bridge. I can repair it, but I am now missing one of the stainless steel brackets that holds the forward part of the windscreen in place. See photo. Please help.

Ok, so I have now owned my 350 mariner for 2 years... last year was my first full season on the Great Lakes and LOVE the boat. Last season I never got to use my Gen as the ball valve on the through hull that was busted in the OFF position. Bummer!! But.. over the winter I did:



* New spark plugs

* New Impeller

* New Impeller coupling

* Oil Filter (did not change oil as I could not warm up the engine, figured I'd do that this year.)

* New Ball Valve, of course.



This year, fired it up and she purred l ...

Hi. My name is Tom. I have a 396MY with Merc 8.1 gas engines. I have been dealing with an issue of stalling out on the starboard engine. I will give you the details. The engines starboard and port, after having be warmed up, once under load and approximately 1/2 hour to an hour underway, the starboard engine stalls out.

After cooling down for approximately 20 to 30 minutes, the engine will be able to be restarted. This has happened on multiple occasions. The boat cannot be trusted.



I have h ...

I have a 1989 Aft Cabin 3807 and the Port Fuel tank is leaking and sitting in fuel ( gas) just noticed the smell about 2 days ago and popped the hatch to see where it was coming from - Looks like the only way to replace the fuel tank is to o the the hull or pull the motor ??

Any help would be greatly appreciated! and where would I get that done?

Matt- San Diego

Hello,
We were lucky enough to break the middle port side salon window on our 2001 Carver 396 Motor Yacht this weekend, the top hinge did not pivot and the glass shattered ; the Carver part number per the manual is 7059196, does anyone know if this part, as well as the top hinges, are still available through Carver or has anyone else had to replace windows for this model and if so where did you find them.

Thanks in advance
High5u