My 2004 466 MY has 9 white cup holders on the bridge. The cup holders have a hole in the bottom and are attached to a hose for drainage. Anyone know where I can get replacements?
Thanks to all.
Walter

Hello,
looking for a little help,,( 1989 3807 Aft Cabin) I was underway yesterday i got about 1000 feet from the dock and when I shifted into neutral, then reverse, both motors were stayed in reverse - the levers shifted fine but but transmissions remained in reverse. even when I put the levers in neutral it stayed in reverse. dropped my hook and had to get towed in. any suggestions.... ? it weird that both transmissions did this at the same time.

Matt

Hello Everyone,



We are just starting to get involved with our new (to us) 1998 355 Aft Cabin. It's in top shape and we love all of it!



One item came up the other day. We turned on a "spare" switch on the 12V panel and a fan was started.



The Red Dot was NOT on and the fan exhaust seemed to be coming out of the heater vents throughout the boat. It was cold air.



Any ideas what I've stumbled onto?



More crazy and ridiculous questions to come. Thanks for everyone's help.



Take Care, Greg

I need to replace the rubber gasket/ tape that is stuck to the underside of the engine hatch covers and generator, but am a pretty new boat owner. Suggestions on tape? Flat or slightly round? Manufacturers?
1999 Carver Mariner 35

Thank you! Ross

Good evening all.

I’m curious to hear opinions from any 3227 owners out there regarding the handling characteristics of their boats.

How are they in chop, how far have you traveled in one. Have you ventured out for some deep sea fishing as their old brochure mentions?

Any and all thoughts on the 3227 Convertible are greatly appreciated.

Good Morning,
I have a 1997 355AC and the shower sump is not working. Checked with a volt meter and I'm not getting any power. I reset all of the breakers and they all appear to be working. Is there a switch or GFCI that the pump may be wired to? We had a bunch of kids on the boat yesterday so anything is possible..

Thanks,

Dan

Hi Guys, I don't know if anyone is interested in this but I had to fix the Perko sliding window anti rattle stops on our Carver. The screws are plastic and they broke. They are a 1/4" x 20 thread. I replaced them with a stainless steel thumbscrew knob.



https://www.amazon.com/gp/product/B07XLTN56C/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1



Then I added one of these to the end. You have to remove the metal insert not hard. It pops right out. Then you thread it on to the end. Will add a lit ...

Silly question. Here we go. I installed a toilet filter in the place of the other filter that was there. Now, when we use it, it still fringing sticks!!!! Is it possible that there is 2 filters or was the one installed incorrectly in the wrong line.

I have always used a home made setup for water filtration as we drink the water from our tank and have been doing so for the last 25 years in no less than 4 boats. Tank must be well maintained which includes an annual bleach/chlorine shock treatment. I learned a long time ago when purchasing something make sure the replacement units are standard otherwise you will not find them or they are ridiculously expensive which is a been there done that when it comes to replacement filter cartridges.
...

I like the 1990 Carver 3608 but I can’t seem to find if they are solid fiberglass below the waterline or cored.